How To Choose Your Solder Fittings

In short, a reducer is exactly like a sleeve except that it allows two pipes of different diameters to be joined together. Learn more about valves such as Everflow Control Valves – Midwest Supply here.

How To Choose Your Solder Fittings

The threaded fitting with a beaten neck allows the assembly of a rigid copper pipe on another element or a fitting to screw. The term ” beaten collar” refers to the shape given to the end of a rigid pipe on which the screw-on fitting is blocked. A seal must be fixed on the flat part created by the beaten collar.

Brass Fitting Or Galvanized Fitting: What’s The Difference?

Galvanized steel offers very good resistance to oxidation in a humid environment and better mechanical resistance to abrasion than brass. It also displays better shear and tensile strength. Its use is not recommended near non-galvanized steel and in a humid environment because galvanic corrosion could occur. They can be used in drinking water and heating circuits (≤ 60°C). Brass is more malleable and has good resistance to oxidation in a humid environment.

How To Choose Your Screw Fittings

A tee is used to join three pipes. It can be male, female, or male/female. The inlet perpendicular to the other two may or may not have the same diameter.

What Is A Bicone Coupling Or Olive Coupling

A bicone fitting from Midwest Supply for example is a solderless brass fitting. Sealing is obtained by a ring, tightened by a nut, and deforms until it crashes between the pipe and the fitting. The first advantage is its ease of use: the olive fitting is mounted with a spanner and does not require any know-how, choose it according to the diameter of the copper pipe and screw.

The olive fitting does not require welding, gaskets, or Teflon (or tow) and is only used with rigid copper pipes (and not coiled). The bicone connector can only be used once: if you unscrew it once installed, it will lose its tightness, and you will have to change the ring (these are detailed).

What Is A PEX Fitting

As we have seen above, PER is a more or less flexible plastic material used for plumbing, sanitary, or heating pipes. This type of installation does not require any special plumbing knowledge. No need to solder, and the material required is relatively limited.

This type of fitting is mainly used in heating networks because, once installed, it is very reliable in terms of strength and possible leaks. The slip fitting requires a certain technique and specific accessories (flaring and crimping pliers).

The crimp fitting allows you to assemble PEX pipes on plumbing elements permanently. The fitting deforms under the action of crimping pliers and becomes definitively attached to the pipe.

Comments are closed.